Turn the vehicle’s ignition switch to the ON position. If your vehicle has a 2×2 port (some pre-1996 vehicles), then use the optional 2×2 Adapter between the Interface and the ports in the car. Next, unplug the USB Interface from your PC, wait 5 seconds and plug it back in.Ĭonnect the car end of your Interface to your vehicle’s Diagnostic Port.
It may be under “Other Devices” or under “Universal Serial Bus Controllers”. On the left side of the screen under System Tools, select Device Manager.įind the “VCDS Compatible USB Interface” or similar and delete it. Select Manage to bring up Computer Management. You can find the Device Manager by right-clicking on My Computer in XP or on Computer in Vista or 7. If, for some reason, you installed the USB Interface without following the above instructions, and VCDS does not work correctly, go into your PC’s Device Manager while the USB Interface is connected. The process should be automated but you may need to click “Continue Anyway” part way through the process. Select “Install the software automatically (Recommended)” then click If you are prompted with the choice, pick “No, Not This Time” when asked if you want to connect to the Internet to search for drivers. If you are using XP or W2000, click on the Found New Hardware message and the Found New Hardware Wizard should start up. The drivers many install automatically in Windows 7 or Vista.
Interface, a message like this should pop up: If you are using a Serial Interface then you can proceed to step #4. If your PC is further from the vehicle’s diagnostic port than 6 feet,Ĭonnect an approved Extension Cable between the PC and the Interface. This generation of interfaces is much faster on modern, CAN-based cars than any of our now discontinued legacy interfaces.This article show a guide on how to configure VCDS diagnostic cable for you laptopĬonnect the USB end of your USB Interface or the Serial end of your Serial Interface to the correct port on your PC.
VCDS-Mobile, while the HEX-V2 is strictly for use with VCDS on a Windows PC via USB. However the HEX-NET can also be used with VCDS wirelessly via WiFi, and it gives you access to Both will also work with many 1990-1995 (OBD-I) cars, but these may require theīoth interfaces can be plugged into any standard USB port on a PC. Ross-Tech can supply two different Interfaces (the hardware needed to connect a PC to your car).īoth of our current interfaces are universal on the car-side, supporting all VW/Audi Group passenger cars from 1996 to current, including k-line andĬAN-Bus diagnostics.
0 kommentar(er)
